Taming Pets on Rust!

Status
Not open for further replies.

Pur3x

CB Owner
Staff member
Messages
244
Likes
125
#1
Taming an animal
You can tame an animal quite simply. Type /pet to activate your pet controller, then stand next to any animal and press the USE key (default). There is a adjustable cool down for taming animals in the config

Issuing commands to your pet (You can set the command keys in the config)
There are 2 keys you can use to control your pet.

The 'USE' key (default) is used to tell your pet to move, attack, and eat.

To issue a move order look at the position you want your NPC to move to and press the USE key. A cyan arrow will appear at the position and your pet will move there. If you have follow enabled the pet will make its way back to you

To feed your pet look at a dead player or animal and press the USE key. The draw system will display a yellow arrow and you will be notified in chat that your pet is trying to eat. This will replenish its energy. A pet will low energy will try to sleep alot.

To issue a attack order look at a target (enemy player or animal) and press the USE key. A red arrow will appear on the target and your pet will begin pursuit. If the target gets too far away from your pet it will give up and return

To open your pets inventory, simply stand next to your pet and press the USE key to open.

These commands are represented by the draw system if it is enabled in the config (explained below)

The 'RELOAD' key (default) is used to command your pet to stay/follow

The draw system
The draw system is very simple, when you give a command to your pet the plugin will show your target. There 3 types of arrow indicators
cyan: Represents a move order
red: Represents an attack order
yellow: Represents and eat order.

 
Status
Not open for further replies.
Top